1 H50003 / H50083 User’s Manual
10L - Speaker Volume This command sets the speaker volume control according to the parameter supplied. Syntax L[<value>] Defined Values &l
11&V - Display Current Configuration and Stored Profile This command reports the current (active) configuration and the stored (user) profiles.
12*B - Display Blacklisted Numbers This command requests the modem to return a list of blacklisted numbers to the DTE. The format of the response is
13V.92 +P and –Q Commands This section describes the +P (PCM DCE) and –Q commands and parameters used to control the V.92 Mode operation. +PCW - C
14+PMH - Modem-on-Hold Enable This command controls the selection of modem-on-hold in the modem. The action of the modem in response to modem-on-hol
15+PMHT – Modem-on-Hold Timer This command controls whether or not the modem will grant or deny a modem-on-hold (MOH) request as well as setting the
16Troubleshooting This appendix contains information that will help you to solve some of the common problems you might encounter, while using this 5
2 Installation Guide Installation Guide for Windows 2000, Windows XP Home / Professional, XP Professional x64 Edition, Vista 32 / 64 Families,
3Installation Guide for Windows 2000, Windows XP Home / Professional, XP Professional x64 Edition, Vista 32 / 64 Families, Windows 7 32 / 64 Familie
4For Windows 2000/XP/2003 User: As Windows starts, it will detect a new hardware has been plugged or added, and start the " Add New Hardwar
513. Please select " Install Driver ".
614. Click " OK ". (For Windows Vista/2008/7 User only) 15. Click " Install ". (For Windows Vista/2008/7 User only)
716. Click " OK ". (For Windows Vista/2008/7 User only) If you can not perform these procedures smoothly as above, please perform the fi
8Basic AT Command Guide T - Set Tone Dial Default This command forces DTMF dialing until the next P dial modifier or P command is received. The mod
9H - Disconnect (Hang-Up) This command initiates a hang up sequence. This command may not be available for some countries due to PTT restrictions.
Comentarios a estos manuales