HiRO H50083 Manual de usuario descargar pdf (Pagina 9)

H - Disconnect (Hang-Up)

This command initiates a hang up sequence. This command may not be available for some countries

due to PTT restrictions.

Syntax

H[<value>]

Defined Values

<value> Decimal number corresponding to the selected option.

0 The modem will release the line if the modem is currently on-line.

1 If on-hook, the modem will go off-hook and remain in command mode.

Result Codes

OK <value> = 0 or 1.

ERROR Otherwise.

O - Return to On-Line Data Mode

This command specifies that the modem will enter the on-line data mode from the on-line command

mode with or without a retrain. If in the off-line command mode when this command is entered, the

modem reports ERROR.

Syntax

O[<value>]

Defined Values

<value> Decimal number corresponding to the selected option.

0 Enters on-line data mode from the on-line command mode without a retrain. Handling is

determined by the Call Establishment task. Generally, if a connection exists, this command

connects the DTE back to the remote modem after an escape (+++).

1 Performs a retrain then enters on-line data mode from the on-line command mode.

Result Codes

OK <value> = 0 or 1 and a connection exists.

ERROR Otherwise or no connection exists

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

HiRO H50083 Manual de usuario Pagina 9